sheet resistance造句
1 Chest laboratory work, the chest materials testing, sheet resistance scratches.
2 The sheet resistance, TVIL and color of ITO films depend on the film thickness.
3 A new method for measuring sheet resistance of semiconductor using four-point probe has been developed.
4 The measured value of particle, sheet resistance and film thickness have been respectively recorded in a table, please see table2.
5 Sheet resistance of films deposited at various substrate temperatures was studied.
6 The sheet resistance of films decreased with an increase of PANI content, while visible light transmittance of the hybrid films also declined.
7 The initial experiments on and analysis of sheet resistance, contact, photomask alignment, line width, and correlations between device parameters and dopants have been made.
8 ITO films with low sheet resistance can be obtained by raising the substrate temperature during deposition or annealing in the inert gases at high temperature.
9 This instrument has been used to measure the sheet resistance distribution for Boron diffusion chip.
10 This instrument has been used for measuring the sheet resistance distribution for Boron diffusion chip.
11 Then, the effects of heat treatment and temperature on the chemical composition and sheet resistance of the prepared films were investigated by XRD, EDXS and sheet resistance measurements.
12 Accomplishing the development of square four point probe instrument with the function of image manipulation for testing sheet resistance automatically .
13 Sheet resistance has the units of ohms , but it is convenient to refer to it in ohms per square since the sheet resistance produces the resistance of the coating within any square area.
14 But the poly resistance has got lower temperature coefficient and lower Sheet Resistance than well resistance So we choose the resistance type depending upon the requirements.
15 In this article, we drive the equations of measuring resistivity and surface sheet resistance, taking into account the contact dimension and putting the location of the four probes arbitrary.
16 A model of calculating electric potential of two dimension point current in measurement of sheet resistance with four-point probe by FEM is presented and its correctness is verified furthe.
17 Of all these factors, the implantation dose has the most significant influence on mobility and sheet resistance.