ejector pin造句
1. Does this an ejector pin or an ejector bar? Can we add an ejector blade?
2. Each ejector pin diameter has a number of different lengths associated with it.
3. Does this part need an ejector pin or bar ? Can we add an ejector blade?
4. Since some components such as ejector pin, locating ring , sprue bush , water junctions and springs are not included in the mould base, these components are purchased independently.
5. The direction of movement of this ejector pin is, therefore, controlled by this hole.
6. An ejector pin (4) is provided immediately below the peg, in addition to the normal ejector system, which in this example is also by means of ejector pins (5).
7. The plain diameter ejector pin may be used in one of two ways.
8. Note that die length of ejector pin contact with the mould plate is kept to a minimum by incorporating a clearance diameter hole in the mould plate.
9. At present, the phenomenon of axial desquamation for an individual ejector pin plate or an annular cutter can occurs in a disposable digestive tract anastomat component.
10. A particular injection mould with submarine gate and two-stage pushing out plastics by cavity plate and ejector pin for thin disk is designed.
11. The forming technology of the cell phone piece was analyzed. The structure of the mould was redesigned to improve the strength of the thin slanted ejector pin.
12. The product has excellent tooling quality and machining performance, so as to alleviate and avoid the deformation of ejector pin because of heat treatment.
13. After mold opening, this pin will function as an ejector pin and ejects the sprue from a sprue bush. Also it releases gas contained in molten plastic.
14. Design of vent system includes vent groove, vent plug and clearance of ejector pin.
15. Restricted by the structure of the part, so the ejector pin should be thin and long, and it is also very important to check its intensity.
16. The runner system was ejected by deviating hole and spherical ejector pin automatically.
17. The structure, operating principle and action of mechanism of automatic sprue cutting by ejector pin in thermosetting plastics injection mould was described.
18. Hydraulic drawing-core mechanism was adopted for two-side of inner-sinking in the die casting die, and pre-resetting mechanism was set to avoid the interference of core slide with ejector pin.
19. Suitable sizes of push-back pins may be selected from a standard ejector pin range.