bluing造句
1. Blue are the hills that are far away.
2. He is in his better blue clothes.
3. The sky is not less blue because the blind man does not see it.
4. I am cought between the devil and the deep blue sea.
5. If you mix blue and yellow, you get green.
6. She emerged from the sea, blue with cold.
7. A hawk hovered in the blue sky.
8. The yellow curtains contrast with the blue bedcover.
9. The walls were besmeared with sticky blue paint.
10. He was wearing faded blue jeans.
11. They were dressed alike in blue jersey and knickers.
12. The plates have a blue stripe round the edge.
13. I'd like to try on that blue wool coat.
14. I've been feeling kind of blue .
15. The news of his death was a bolt from the blue.
16. From majestic mountains and valleys of GREen to crystal clear waters so blue, this wish is coming to you.
17. The painting portrays a beautiful young woman in a blue dress.
18. She was wearing two blue silk ribbons in her hair.
19. The butterfly is black and white with a blue stripe running down each wing.
20. Most pop music is influenced, to a greater or lesser degree, by the blues.
21. A new technology and equipment of annealing and bluing for finished stator and rotor of uncoated cold-rolled electric steel lamination in bell-type hydrogen furnace was introduced.
22. Pretreatment, bluing and post treatment of this process were introduced.
23. There was a gentle bluing of the skin after death.
24. A new technology and equipment of annealing and bluing for finished stator and rotor of uncoated cold-rolled electric steel lamination in bell-type hytrogen furnace was introduced.
25. BLUING / BLUE UP : Process of using blue dye to coat a surface of a master, gauge, or piece of product to check a flat, circular, or tapered surface.
26. Bluing: also blueing , any of various coloring agents used to counteract the yellowing of laundered fabrics.
27. The production shows that the best bluing time in normal temperature is from 4 to 8 minutes and bluing film is bright and anti-corrosion capacity is at or higher than the specified state standard.
28. Adhesion, wear and corrosion resistance of the coatings obtained were compared with those of conventional bluing at room temperature.
29. Tapered bores for keyed hubs shall have a minimum of 70% transfer of bluing (surface contact) to the taper gage.
30. Illustrated in detail the whole process and cautions of basic bluing treatment from solution preparation, oxidization to operation procedure.
12