voltage rating造句
1) This standard includes updates to the definitions, voltage rating and interrupting rating tables, and the current carrying and temperature rise tests.
2) Suggestions are given on the voltage rating of actual compensation capacitors.
3) The voltage rating can be quite low (6V for example) and it should always be checked when selecting an electrolytic capacitor.
4) The voltage rating ( if there is one ) is almost meaningless.
5) The voltage rating of these resistors must be at least equal to the test voltage.
6) With parallel operation the output voltage is equal to the voltage rating of one winding,[http:///voltage rating.html] or 6 volts in this case.
7) Readers will doubtless already be well aware that the voltage ratings quoted for electrolytic capacitors are really quite important.
8) For a transformer type ballast, the voltage value to be applied from this table is the rms voltage rating of the capacitor as specified on the ballast.
9) The forward voltage drop in the on-state is only a few volts(typically 1 to 3 V depending on the device blocking voltage rating).
10) Grid voltage in accordance with corporate standards and requirements for power factor to determine the motor's voltage rating and type.
11) MICRO fuse, very fast-acting type. Radial lead. Ampere rating 8/10 Nominal resistance cold 0.271 Ohms. Voltage rating 125.
12) IT equipment could be operating at its least efficient voltage rating.
13) MICRO fuse, very fast-acting type. Plug-in. Ampere rating 5. Nominal resistance cold 0.0156 Ohms. Voltage rating 125.
14) MICRO fuse, very fast-acting type. Radial lead. Ampere rating 6/10. Nominal resistance cold 0.430 Ohms. Voltage rating 125.
15) The refrigerator should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating plate.
16) Generators in this size range will be offered by the manufacturer in accordance with its design, and it would be difficult and expensive to get a different voltage rating.
17) It is easy to find the value of electrolytic capacitors because they are clearly printed with their capacitance and voltage rating.
18) It is important to ensure that the total cell voltage across the string does not exceed the common mode voltage rating and the maximum voltage level of the switch module.
19) When a relay is used near its power or voltage rating, the duty cycle must be adjusted to allow for cooling time.
20) The attachment plug shall be of a type with a current rating not less than that of the appliance, and the voltage rating equal to the rated voltage of the appliance.
21) Ignore any letters - they just indicate tolerance and voltage rating.
22) The test voltage shall be the nominal system voltage corresponding to the ballast input voltage rating, as specified in Table 16.3.3.1.
23) MICRO fuse, very fast-acting type. Plug-in. Ampere rating 4. Nominal resistance cold 0.0202 Ohms. Voltage rating 125.
24) How fast will an increment of the excitation voltage reach 95% of the difference between ceiling voltage and the system voltage rating.