loss factor造句1 The results show that the loss factor of a laminated structure is stepped up by using magnetostrictive material as the constrained layer.
2 The parameters of non-destructive testing, such as dielectric loss factor, capacity and the voltage at which the charging current increases abruptly, are measured in the different aging stage.
3 The Influence of the loss factor, thickness and flake filler on the sound isolation performance of polyurethane elastomer is studied.
4 Precision of on-line dielectric loss factor monitoring can be affected by environmental factors, so it is necessary to modify it.
5 The effect of dielectric constant, dielectric loss factor, coefficient of thermal expansion (CTE)and characteristic impedance of substrate materials on properties of MMB are mainly discussed.
6 For photoflash, lead wire type, small size, Low loss factor, high stability.
7 Because the loss factor and the corresponding scaling function are defined as the same fuzzy membership function, it can overcome the problems for fuzzy algorithms of GLVQ network possess.
8 For phlto - flash, Lug type, Low loss factor and low leakage current.
9 For photoflash, lug type, low loss factor and low leakage current.
10 Added powder filler and short glass fibres can improve the impact strength and loss factor obviously.
11 Provided is a method of efficiently and strongly joining ceramics even when they are ceramics of extremely low dielectric loss factor, such as aluminum nitride.
12 Because of the lack of the harmonic analytical approach, the modified harmonic analytical approach is proposed to calculate the dielectric loss factor.
13 The results showed that the relative dielectric constant of pork was decreased with increasing frequency, and the dielectric loss factor reached a minimum at 2500MHz.
14 Absorption loss due to high harmonics of C-H vibrations, the primary loss factor in PMMA POF, was analyzed and calculated. And the results were consistent with measured datas.
15 In this paper, an on-line insulation monitor based on DSP is developed to measure the dielectric loss factor more accurately.
16 The important parameters for the wave absorption effects are electromagnetic loss factor, complex dielectric constant,[www.] complex magnetic conductivity.
17 And the charge density of oil streaming electrification is related to the dielectric loss factor and conductivity.
18 The experimental results show that the device can accurately measure the dielectric loss factor.
19 The magnetic core consists of imported oriental crystal laminations with a very low loss factor.
20 TGA and High Voltage Bridge are used to test the dielectric loss factor and the breakdown voltage of the solvent-free insulating varnish.