dead time造句1. Owing to the difficulty of identifying dead time parameter of industrial process, a kind of new step response method is presented to identify dead time parameter of industrial process.
2. For the situation with dead time and constraints, a control strategy of increment model algorithm was developed using goal programming as optimal strategy.
3. The dissertation analyzes harmonic current and the dead time effect of inverter.
4. This paper investigates the effect of dead time on common-mode voltage for PWM inverter.
4.try its best to collect and create good sentences.
5. A kind of object reference parameter adaptive dead time compensator is presented. A group of models are Used to simulate the uncertain process with large dead time.
6. Integrator and dead time process is a special case of unstable systems.
7. The delay time is also referred to as dead time.
8. This causes well known dead time effect which distorts the output voltage and current.
9. Aiming at the long dead time object, this paper presents a simulating human intelligent controller.
10. Finally, a dead time compensation method based on control chip MR 16 was implemented.
11. This paper presents a new method for dead time , the quasi - single - polarity PWM method.
12. This keeps the interest of the viewer, since there is no dead time between actions.
13. A group of models are Used to simulate the uncertain process with large dead time.
14. The drive circuit adopts gate charge retention(GCR) technology, resolves the dead time of secondary synchronous rectifiers, reduces the loss of them, enhances the efficiency of the converter.
15. This article discusses about two valid Methods: To correct the dead time.
16. The schottky diode bypasses the gate resistor in the gate discharge path, so that there is no falling edge delay. The delay at the rising edge adds dead time.
17. For nuclear spectrum measurement in nuclear analysis, the correction of dead time in multi channel pulse amplitude analyzer must be considered.
18. The turn-on and turn-off of power devices under zero voltage are realized with addition of dead time. The power supply for GTO gate driver is developed by use of the converter.