signal-to-noise造句
(1) Four observations were excluded because of low signal-to-noise ratio or background subtraction problems.
(2) The test data of bit error rate and signal-to-noise ratio show that the performance of the receiver terminal is available, which guarantees the accuracy of the data after the forward error correction.
(3) The actual signal-to-noise ratio criterion of photon correlation spectrum, its building-up process and its shortages were summarized.
(4) The theoretical formula of output signal-to-noise ratio involving quantization noise and round-off noise are derived.
(5) Test results showed that noises were depressed well, signal-to-noise ratio was improved obviously, and flaw location accuracy and longitudinal resolution were improved by using the method.
(6) The peak signal-to-noise ratio(PSNR)of the reconstructed image is improved compared to still image compression algorithm of MPEG-4at the same bit ratio.
(7) Brightness, signal-to-noise ratio, viewing angle and monochromaticity are the main quality index of a hologram.
(8) The result improves on that the peak signal-to-noise ratio and the visual effect of image restoration via the proposed process. The rapid speed based on convolution ensures real-time of the algorithm.
(9) And when the signal-to-noise rate is under some value, separated signals will be bad.
(10) In order to calculate the signal-to-noise ratio, a calculation method for output noise power spectrum in an active integrator and clamp circuit is presented.
(11) Since the amount of information to be conveyed remains much the same this means that the signal-to-noise ratio will be worse.
(12) It is possible to detect individual pulses from this millisecond pulsar with high signal-to-noise ratio in unbroken trains.
(13) The simulation results indicate that the new algorithm greatly improves the peak signal-to-noise ratio (PSNR) of the reconstructed image compared with EZW.
(14) The time frequency difference between grain noise and defect signal provide a possibility for enhancement of signal-to-noise ratio(SNR) in ultrasonic testing.
(15) The results of field test showed that adopting cascade geophone pattern can be results of good continuation of phase, enhanced amplitude and high signal-to-noise ratio on the records.
(16) The radiofrequency coil, as the first stage of the receive chain, is the main factor of signal-to-noise ratio.
(17) The microphone is used in a data acquisition system on a personal computer. The phonocardiogram and speech signals possessing high signal-to-noise ratio can be obtained.
(18) In order to emulate and evaluate the system performance, the signal-to-noise (SNR) and probability of detection (Pd) vs. the gain and threshold voltage of APD arrays were discussed in this paper.
(19) Finally, the table of the optimal loop parameter values under different signal-to-noise ratios is presented.
(20) For infrared image with the characteristics of low contrast and low signal-to-noise, a infrared image enhancement method based on Wavelet Transform and Lateral Inhibition Network is presented.
(21) Second, by means of wavelet multi-resolution analysis, separating modulating signal from radiated noise of naval ships has been simulated and realized with moderate and low signal-to-noise rate.
(22) The stopping time is chosen by minimal mean square error, signal-to-noise ratio and minimal correlation coefficient based on the information of the original (ideal) images and noises.
(23) It utilizes spectral envelope estimation to obtain envelope and peak signal and calculates signal-to-noise ratio of speech harmonics in iterate form under least square estimate criterion.
(24) In the receiving system, the narrow-band interference filter is introduced in order to reduce the background light, increase the signal transmission rate, and improve the signal-to-noise ratio.
(25) Yang argued for a "quantitative evaluation of GNSS interoperability, " noting that common maximum/minimum received power levels can improve the signal-to-noise environment for multisystem receivers.
(26) Compared with DC coupling signal processing, it need lower requirement of signal processing circuit and have the merit of high signal-to-noise performance although it require the device of modem.
(27) Traditional short-term autocorrelation-based adaptive line spectrum enhancer (SABALSE) becomes low in suppressing Gaussian noise when input signal-to-noise ratio becomes low.
(28) Experimental results show that the algorithm can achieve higher peak signal-to-noise ratio (PSNR) and better video quality compared with other existing algorithms.
(29) The filter technique based on Walsh transform is used to suppress seismic noise in order to improve the signal-to-noise ratio of seismic data.
(30) Some of the downward first motion records from the nuclear explosions is probably that of th second half-cycle of the initial wave owing to lower signal-to-noise ratio.
12