快好知 kuaihz


flyback造句
31. The paper introduces the research of switching power supply for speak-louder. introduces the principle of the Flyback mode switching power supply. 32. A simple, low - cost, isolated flyback power supply energizes a DVM module. 33. In this paper, the optimum design is employed for a single - ended flyback converter with four outputs. 34. A new feedback circuit , which is designed based on PWM controller UC3842 of flyback switching mode power supply is presented. 35. The sensing error can be improved by sampling instant modulation for DCM DC - DC flyback converters. 36. However, due to leakage effects flyback converter power switch off when the voltage spike caused by the need to be inhibited by clamping circuit. 37. The auxiliary circuit is composed of an auxiliary switch, a coupled inductor(flyback transformer) and a feedback diode. 38. In this flyback example only the primary switch has been analyzed active source of electrical noise. 39. The PLL2 phase detector is similar to the PLL1 detector and compares the line flyback pulse at HFLB (pin 1) with the oscillator sawtooth voltage. 40. The leakage inductance of transformer has huge influence on the energy returned stage of double - flyback converter. 41. First and foremost, the paper raises a single stage, single switch and high efficiency PFC converter topology. It combines with PFC circuit and the Flyback converter which owes center tap transformer. 42. The early failure phenomena of flyback transformer was discussed in this paper. 43. At last,[Sentence dictionary] a prototype based on the novel interleaved flyback converter is accomplished and experimentally verified. 44. This paper presents a novel flyback DC/DC converter. By adding a simple auxiliary circuit, its switch can achieve ZVT condition, thus both the switching losses and EMI can be reduced. 45. To achieve the standby mode system operations, the Tinyswitch flyback converter which features low no-load loss is used for the auxiliary power circuit. 46. A flyback converter with zero current switching ( ZCS ) resonant and power factor correct ( PFC ) is proposed. 47. CMOS output with an emitter follower can drive a 5V relay nicely as the relays normally have a spec of 3.5V. This saves power and require no flyback components.