failure mode造句
31. The primary failure mode of commomly used circuit protective devices is short-circuit, and so is TVS (Transient Voltage Suppressor) .
32. In the present work, a rarely observed failure mode of dual-shell U-tube heat exchanger was studied, and the preliminary reason of the failure was discussed.
33. The failure mode includes positive grid corrosion, sulfation , runaway, negative strap corrosion and short circuit etc.
34. Succinct has proved the two - broken line modified failure mode is effective and feasible.
35. DFMEA process can't ensure all the failure mode was covered.
36. It is determined that main failure mode for failed products is bad contact through failure analysis on products, failed during life test.
37. Ye Tan: Wong Kwong Yu declared the failure of financial failure mode?
38. This paper proposes a vector algorithm based on the famous failure mode and effect analysis as an approach to reliability evaluation of a complex distribution system.
39. Claim statistical data indicated that truck clutch release bearing had high failure rate, the failure mode including abnormal noise, ablation, oil starvation and wear of bearing block shoulder, etc.
40. This failure mode would have been extremely difficult to detect with any other diagnostic technique.
41. Are process capability studies including Failure Mode Effects Analysis ( FMEA's ) conducted where applicable?
42. Causality diagram methodology is a probabilistic reasoning, which can be applied to fault analysis. However, it lacks analysis on the importance of failure mode.
43. At least 3 years of product design experience such as Good Drawing Office practices, Tolerance Analysis, Design For Assembly, Failure Mode and Effect Analysis (FMEA).
44. The main failure mode of the automobile engine cylinder is wear.
45. Local buckling is the dominant failure mode for composite steel column.
46. Fastener common failure mode of failure of the assembly has elongated,[http:///failure mode.html] fatigue fracture and delayed fracture.
47. Developing and auditing Design Failure Mode and Effect Analysis ( DFMEA ).
48. Performance of cold mill work rolls is dependent to a great extent on spalling resistance, so that both of roll manufacturers and users show great interest in this failure mode.
49. The reliability index was applied on basis of the analysis on the failure mode. And according to the sampling theory of reliability a reliability test method was put forward.
50. The RPN value from the reliability analysis of the major failure mode provides an important basic reference for the future use and maintenance.
51. Apply the FMEA method to analyze failure mode effect of a fuel cell bus power train.
12