heat treatment造句(121) The heat treatment regimes of the alloy are constituted by means of the DTA curve analysis and a trial and error method.
(122) Influence of different - heat treatment on low temperature salt - bath chromizing of T 10 steel was studied.
(123) So it is meaningful to further study its heat treatment performance by process test, so that the heat treatment process standard is established to meet special requirement.
(124) The homogenization is an important heat treatment step during wrought aluminium alloy production, it influences greatly the quality of the products.
(125) Effects of heat treatment on microstructure of aluminosilicate short fiber reinforced ZL108 composites prepared by squeezing casting have been observed.
(126) The working principle, structure and parameters design of plasma arc generator for heat treatment are described. Experiment has shown that it has good effect on partial surface hardening.
(127) Heat treatment technics such as tempering, vibration aging, induction quenching and so on adopted on key parts like bed enable more stable accuracy and longer working life.
(128) In this article, some typical problems about post welding heat treatment, standards and fabrication were discussed.
(129) To introduce the production process technology of rough drawing, heat treatment and finish drawing of heavy coil steel wire and the transportation manner among procedures.
(130) Chlorophyll-Protein binding capacity, intermediate products of Chlorophyll degradation and POD activity were measured to determine the green keeping mechanism of Pak Choi heat treatment.
(131) It emphatically discussed the problems such as material selection, spheroidizing inoculation treatment, heat treatment, technological parameter control of centrifugal casting, etc.
(132) This banded structure can be eliminated by means of heat treatment.
(133) The fracture toughness values of vermicular graphite cast iron specimen subjected to four different heat treatment methods were tested and compared.
(134) Add the Batch No. to balance shaft in heat treatment report.
(135) Heat treatment by the water into after air fan - coil unit for heat pump, returns to handle.
(136) Numerical model was established after considering solidification, shake out, clearing getting system and heat treatment to predict the casting deformation during hot working processes.
(137) The oxidation of boronized knives during heat treatment depends chiefly upon the oxidizing power of the quenching medium, this problem has been solved by using the water quenching oil cooling process.
(138) And the experimental results of laser hardened V-guide slide were compared with those of common heat treatment.
(139) In regard to non wear resistance of the white iron shot in the practical application process, alloy iron shot have been produced by means of adding alloying element and proper heat treatment.
(140) In order to achieve different purposes, gray cast iron casting be out at different heat treatment.
(141) The ZG45 half gearing circle broken during heat treatment was studied and analysed by metallograph and SEM.
(142) To design and dispose all the electric control system according to the process requirements of mixture coal gas heat treatment production line.
(143) Electron beam post - weld local heat treatment is anew kind of heat treatment method.
(144) Thus, heat treatment had more effect on ovalbumin antigenicity than high-pressure microfluidization. This conclusion is helpful for the development of hypoallergenic or non-allergenic egg products.
(145) The effect of heat treatment on damping capacity of commercial AZ91D Magnesium alloys were studied by dynamic mechanical analyzer (DMA).
(146) In addition, the atmosphere in heat treatment, chemical composition and different sources of nitrides can influence the crystallization of oxynitride glasses.
(147) Heat treatment on the preparation, structure, electrovalence of silver, releasing speed of Ag ions and antibacterial property of obtained blocks were investigated.
(148) This pseudopearlitic banded structure can be eliminated by means of heat treatment.
(149) The steel and the heat treatment process of fine heavy load drift was determined by means of production tests. And the satisfactory result was obtained.
(150) The research result indicates that, when bimetal material is certain, the size of heat treatment mandrill and the temperature of re-crystallized anneal would decide the end size of bimetals wreaths.