flux density造句
(1) As the winding current is increased, however, the flux density in the iron eventually reaches its saturation level.
(2) The spin-down energy flux density is the third highest known, after the Crab and Vela pulsars.
(3) Although the relative strengths of these components varied, the absolute flux densities of all components generally decreased during January to June.
(4) Figure 2 shows the time variation of the flux densities and velocities at peak intensities for the strongest four redshifted components at.
(5) The integrated flux density for the shell in Fig. 1 is 3.280.24Jy.
(6) Lower power loss material with high saturation flux density.
(7) Grain growth is favourable for increasing magnetic flux density.
(8) In center column of core , magnetic flux density is reduced by counteraction.
(9) At the same gap width, the magnetic flux density increases with an increase in stirring current, but decreases with the stirring frequency increasing.
(10) In calculating the magnetic flux density B between two blocks of parallel block capacitors, there are two common solutions, one of which is not correct.
(11) High saturation flux density can improve the work point of transformers and reduce the volume of power supply.
(12) Powder core has high saturation flux density and excellent motion linearity of DC bias.
(13) The magnetic flux density is uniform near the center of coil, therefore, the meniscus level in mold should locates between the coil center and the top of mold in casting operation.
(14) The time - resolved neutron flux density measurement system on HT - 7 Tokamak is presented in the paper.
(15) Relationship between MRF' s yield stress and magnetic flux density, the shear stress and magnetic flux density and shears tress and shear rate were investigated.
(16) At the same current and frequency, the magnetic flux density increases as the stirring gap width decreases gradually.
(17) The maximum electromagnetic force is in direct proportion to the square of magnetic flux density and in inverse proportion to the current frequency.
(18) In this study, a universal theory for the field synergy principle is obtained through the analysis and establishing an equation for the total heat flux density vector divergence.
(19) The iron loss can be reduced greatly if amorphous or ultra-fine crystalline core is used and the flux density is reasonable.
(20) The average flow rate along the channel axes of the molten channel is in direct proportion to the magnetic flux density and in inverse proportion to the square root of the density of the molten metal.
(21) The research showed that the control result of electromagnetic brake was related to casting speed, mould angle and magnetic flux density.
(22) The power loss is lower than NH2B material with high saturation flux density.
(23) The results show that the dynamic behavior of the novel damper is easily controlled by adjusting the magnetic flux density in the radial clearance.
(24) Sap flow density is low and anomalistic, even formed multi-peak curves which has not obvious peak value during rainy days, sap flux density during night is larger than its in sunny days.
(25) Using the proposed model, the relation between the magnetic flux density in the air of the giant magnetostrictive force sensor and the value of force applied on the magnetostrictive rod is calculated.
(26) By numerical analysis, a series of curves are given to describe the magnetic flux density distribution character of the flat spiral coil.
(27) Considering the inconvenience of using the magnetic vector potential as state variable, magnetic flux density is used as the state variable in the design optimization.
(28) A xenon poison method is proposed for measurement of thermal neutron flux density.
(29) An empirical formula describing the dependence of the power of hysteresis loss on frequency, magnetic flux density and temperature was derived.
(30) Firstly, SRM magnetic field analysis is performed to get the flux density waveforms in motor core.
12