transmission line造句
31. A fault locator for power transmission line using 80C196MCU system as its core is developed based on the method.
32. This paper analyzes the influence of fast busbar differential protection caused by distributed capacitance in high-voltage long - distance transmission line during transient process.
33. A method, which forms start component of microprocessor based transmission line relay protection by the principle of wavelet analysis is discussed.
34. In the new design, several fixed test points on a transmission line are chosen instead of previously frequency scanning. We have composed an automatic test system.
35. Distribution capacitance on transmission line often alters with scale factor and phase of microsyn AC output.
36. The traveling wave propagation rule is validated by simulation for transmission line model and results show the correctness of theoretical analysis.
37. A method of generalized capacitance matrix is presented in this paper, which can be used to calculate TEM transmission line comb-line filter and interdigital filter.
38. First, the distributed parameter model and the lumped parameter model of transmission line are given.
39. The calculated value is basically the same as the experimental one with taking self-inductance of transmission line into account.
40. First, the distributed parameter model and the lumped parameter model of transmission line are given. Then, the conversion formulae between each other are also given.
41. Based on the enumeration of the cut sets for the load point interruption, load transition character, maintenance of devices, active failure mode and overload of transmission line are all discussed.
42. There is disclosed a dielectric antenna comprising a dielectric resonator mounted in direct contact with a microstrip transmission line formed on one side of a printed circuit board .
43. A line driver used to fan out to multiple receivers via a transmission line.
44. Based on the wavelet transform of multi-end transient currents a novel protection algorithm for High Voltage transmission line is presented.
45. The connection of a device or circuit in parallel with a transmission line.
46. This paper presents a fiber communication scheme applied to the current differential protection of the high voltage transmission line.
47. Based on the distributed parameter model for transmission line, a new fault location method for short circuit fault of two points on different phases of the power transmission line is presented.
48. Mircrostrip and waveguide are two important kinds of microwave transmission line which are widely used in microwave area.
49. The numerical results were obtained in a table by solving the combined equation of transmission line impedance transfer equation and terminal input impedance expression in gas capacitance.
50. Therefore, it has great significance to research DC icing test methods on disk-shaped suspension insulator for study of DC transmission line characteristics of external insulation.
51. When using frequency sweep meter to measure the input impedance of antenna, the balanced- unbalanced transformer must be connected between coaxial transmission line and antenna.
52. This paper is a report of the designing and making of a UWB pulse generator using SRD(step recovery diode) and microwave transmission line and by means of intervention and elimination.
53. End, put forward the optimal measure of applied OPGW of transmission line.
54. Because of large capacitive charging of long AC transmission line, capacitance reaction of no loaded line will cause severe overvoltage.
55. The precise location of high - voltage transmission line fault is of great significance and practical engineering value.
56. The constitution, primary technique target and the transmission line structure of the subnanosecond EMP simulator are introduced in this paper.
57. Finally, the FDTD method is extended to the non - uniform transmission line.
58. This paper uses multi - conductor transmission line ( MTL ) to model transformer windings.
59. The base principal in controlling method is madding aerodynamic force acting on transmission line changed into approximate balance state.
60. Checking the way the power transmission line pole is fixed.
123456