preheating造句
1. Preheat the oven to 200 degrees C.
2. Preheat the oven to 425 degrees.
3. Preheat the oven to a temperature of 200 degrees Celsius.
4. Stuff the turkey, then put it into a pre-heated oven.
5. Preheat the oven to 400 degrees.
6. Preheat the oven to 375 degrees.
7. Bake for 5-7 minutes in a preheated oven.
8. Preheat the oven to gas Mark 6.
9. Preheat the oven to gas mark 4.
10. Preheat the oven to 190°C.
11. Preheat the grill to medium.
12. Cook the pie for 20 minutes in a pre-heated oven.
12.try its best to gather and build good sentences.
13. Bake in the preheated oven for 25 minutes or until golden brown.
14. Spoon the mixture on to the biscuit base and cook in a pre-heated oven.
15. It was also the first to use controlled pre-heating of boiler feed-water.
16. Power is instantaneous, which means that no preheating time is required, so overall cooking times are reduced.
17. Cover and bake in a preheated oven at 180C, 350F or Gas Mark 4 for 25-45 minutes.
18. Brush each bun with a little beaten egg, then place in the pre-heated oven.
19. Add rabbit pieces. Cover pot and bake in preheated oven for 1 hour.
20. Cover pot and bake in preheated oven for 1 hour.
21. Preheat the oven to the baking temperature suggested in the pie recipe you are using.
22. With preheating temperature enhancing, the peak value also increase, but cooling velocity decreases, resulting from the decrease of heat conductivity of sample lower surface.
23. Proper selection of materials, preheating and postheating can help to avoid cracking.
24. Preheating zone with taper design, use heaters heating, temperature can control, can meet all kinds of insulation varnish requirements.
25. Put a cookie sheet on the oven rack during preheating.
26. The results show that domestic T23 steel has a weak cold crack sensitivity, and preheating can obviously improve the anti-cold crack ability.
27. The influence of laser power, scanning speed, powder feed rate, spot diameter and preheating on the temperature of molten pool were revealed in the process of single-pass cladding.
28. The problems of power supply for diesel locomotive auxiliaries, preheating of oil and water, as well as air conditioner invertor, were pointed out.
29. Preheating shall also be applied to the tack welding , when the weldment requires preheating.
30. The process design for ignition furnace in sintering production to use B. F . gas as the only fuel with preheating technique and its application are introduced.
123