potentiometer造句
1. Turn the sliding contact of the potentiometer to approximately mid-position.
2. Turn the sliding contact of the potentiometer to approximately mid-position. Connect the battery.
3. The 1M potentiometer should be prepared by attaching short wires to the centre and one of its outer terminals.
4. Don't blindly turn this potentiometer.
5. Digital potentiometer sensitivity adjustment and breakage location.
6. In electronics, the moveable arm of a potentiometer.
7. Lead in Trimmer Potentiometer elements.
8. Lead in cermet - based trimmer potentiometer elements.
9. The technique character of the potentiometer cover was introduced.
10. A servo potentiometer that generates the signal for comparison with the input signal.
11. The wiper of the potentiometer is connected directly to the spindle.
12. Nut is widely used in electronic components, potentiometer, quartz core machine, lamp and so on.
13. Potentiometer should not be wiry, but it is desirable to coal or multiturn .
14. The digital potentiometer's bandwidth determines the maximum data rate for signals transmitted through the potentiometer.
15. In this paper , the autocontrol to Potentiometer Drill machine by industrial computers will be achieved.
16. In the contemporary acoustic equipment, usually uses the potentiometer to carry on the volume control.
17. Nonpolarized capacitor C1 and potentiometer R2, a linear taper, determine the time constant of integrator IC1B.
18. As the computer technologies are applied widely, the potentiometer is used for the characteristic measurement of H.
19. The potentiometer is set up so that it gives a positive voltage when the missile accelerates and a negative voltage when it decelerates .
20. The three terminals of the potentiometer are available for use as either a variable resistor or a resistor divider.
21. You can program the digital potentiometer through its serial interface during board or system test.
22. Take OMRON CPM1A as an example, the changing setting value methods in which we use analog input potentiometer, dial switch and push-switch are introduced.
23. The threshold value signal of two-valued is offered by Digital potentiometer which is controlled by SCM.
24. Being a linear output indicator completed with precision multi-turn wirewound potentiometer.
25. Hardware design includes circuits of signal amplification of digital potentiometer, analog switch, A/D conversion, wave conversion, single-chip and peripheral equipment.
26. Principle of high voltage power supply based on PWM chip TL494 is introduced in this paper. The adjustment of the voltage is performed by digital potentiometer controlled by MCU.
27. It also introduces a method according to the actual situation to put a fixed resistance combination of potentiometer, and it improved the accuracy of circuit.
28. This paper analysed the uncertainties of voltmeter in calibration by potentiometer.
29. The major way to improve the linear precision of Rotary Synthetic Carbon Film Potentiometer is to trim resistance using the advanced equipments.
30. The temperature sensors, start switch S1, and current control potentiometer are all connected to the board using servo lead wire (available at many hobby shops in 10 foot lengths).
12