position control造句
1) The system thus had both velocity and position control.
2) Using electronic fluid position control device, automatic water system.
3) The length-given link, velocity-given link, position control and change-over link of cutting head and fixed length cutting have been emphatically analyzed and worked out.
4) A automatic position control system (APC) imported from Hitachi Co. Ltd Japan is analysed in this paper, which is now being used in the blooming mill of Baoshan Iron and Steel Works.
5) Making out saw control model and position control model , Heavy H-beam saw control model resolve the speed and overload relation between hot saw and cold saw, making short about the saw cycle.
6) The provideressinside a position control element shingl link to function as control unit via earningsly supervised two-wire circuit.
7) The structure of APC ( automatic position control ) system is given, the APC algorithms of is deduced.
8) In order to realize rotor position control in the magnetic bearing system, a closed loop position feedback control system is needed to be established.
9) The position control card POSCON controls a complete servo axis.
10) Position control of d . c . motors has been done by means of pulse width modulation.
11) In this paper the new type phase position control trigger circuit of multifunction is designed.
12) The experiment shows hat the position control system has ideal performance and simple algorithm suitable for real-time control.
13) The simulation results show that this proposed controller can obtain better position control characteristic and the position tracking error goes to zero asymptotically.
14) Use is made of a quasi-randon coherence function computer to carry out on-line identification for a typical chydroelectric servo position control system.
15) In the first two movements, the patch head which is fixed on the shaft of voice coil motor do not need to press the chip, so the control method is mainly position control.
16) At present mostly magnetic bearings use the position sensors to realize rotor position control bearing system.
17) A rigid controller for the unmeasured vibration states was designed and a compensatory method for the impact on position control caused by system dynamics was given.
18) Moreover, an application specific integrated circuit(ASIC) of SRM named SR3P10K07A was designed for the prototype, which owns proper hardware functions such as the angular position control and so on.
19) In flying height measuring method utilizing light intensity interference principle, the position control of micro flying head has effect on measuring error.
20) Double shafts type unwinder with automatic positioning control, automatic tension control, automatic edge position control ( EPC ).
21) Based on the untethered AUV developed by our institute, this paper analyzes the navigation control and the position control methods of AUV.
22) PID control based on iterative control compensation is used in position control part.
23) When rotational inertia increases, the proportion coefficient of adjuster must be descend to ensure position control system to be critical damp course.
24) Worker can adjust the handle and seat to make fit to his or her own body type with Position Control Lever, which relieve workers fatigue when operating for hours.
25) Its digital regulator performs calculations according to the equation which is satisfied with conditions of cutting work, and forms a closed loop position control.
26) The control performs turbine speed control off - line, and throttle pressure or valve position control on - line.
27) A method is presented to describe dynamic response curves in the polar coordinates and it is very suitable for the angular position control systems.
28) The high - speed system offers unparalleled sample imaging and position control.
29) It is also equipped with PLC to realize complicated position control of the whole mechanical arm.
30) The same contactors are used for ordinary two - position control.
12