divider造句61. It is an important impact on measurement veracity and response time of the resistance divider for the stray capacitance, especially high voltage divider.
62. The three terminals of the potentiometer are available for use as either a variable resistor or a resistor divider.
63. In the end, the author introduces DGS's applications in microwave circuit in detail, has designed high stages lowpass filter of DGS structure and Power Divider using asymmetric spiral DGS structure.
64. This programmable control voltage divider is a secondary divider used for HV impulse test and an intelligent apparatus consisting of chip microprocessor AT89C51 and peripheral circuit.
65. A frequency low power divide - by - 2 Injection - Locked Frequency Divider ( ILFD ) is presented.
66. In this paper, on the reference of a great deal of documents, the whole scheme design of electronic transducers are finished based on Hall element and accurate capacitor voltage divider.
67. Like the pork pie, black pudding is a great divider with the anti camp’s regular squeals of “you know it’s made with blood don’t you?”
68. This paper describes a noise analysis method for a phase switching frequency divider.
69. The application of bending pin mechanism for sequential demolding is effective for the stripping of hooked zone in the outshot part of the air conditioner current divider.
70. Additionally, a highly precise coder on the shaft is researched. A simple and effective frequency divider is designed for correlative calculation.
71. In a normal transformer circuit, the hum voltage forms a voltage divider between the plate resistance and the load.
72. A precision divider box divides the voltage source down to roughly the standard cell voltage.
73. The theory of operation for a very high-speed ECL multi-modul frequency divider and its circuit and layout design are described. along with its fabrication process.
74. Based on system-level model simulation, we determinate the key parameter of the pll system such as charge pump current, loop bandwidth, phase margin, VCO gain, divider modulus,[http:///divider.html] etc.
75. The CNC fineinterpolator based on pulse multiplication has its inherent error, which caused by the rounding of frequency divider parameters.
76. The speed of latch has a direct effect on the performance of divider, which can be improved by separating trace differential pair and cross-coupled pair and decreasing the bias current of the later.
77. These may be realized by power divider and phase shifter.
78. Aiming at the phase error of the electronic voltage transformer(EVT) with capacitive divider, a phase compensation scheme was proposed.
79. Measuring discharging current with current divider, and measuring magnetic induction intensity with magnetic test coil are feasible in practice.
80. Based on the low thermal EMF divider, a low DC voltage calibration system is developed for DC digital nanovoltmeter calibration.
81. The default visibility of the divider line for ALL org chart shapes.
82. The power divider for ensuring two AO Q? switch synchronization and effective power driving is designed.
83. A programmable divider used in frequency synthesizer of Rb frequency standard is designed, and the improvement of programmable divider is introduced.
84. This paper improves the characteristics of lumped element impedance transformers and proposes new type power divider circuit and its design method.
85. All cell circuits such as analog multiplier, seeking small and sum, divider were implemented on 8 AN221E04s, and then an intact controller was assembled with the cell circuits.
86. Voila 20 MHz. If we used a programmable divider here we could change frequencies on the fly.
87. Design an 8-bit digital divider, the 8-bit prescaler extended to 16-bit CNC CNC divider.
88. When choosing values for R3 and R4 to set the desired trip voltage, ensure that they are large enough that the potential divider will not excessively load the supply.
89. The ratio error of the divider calibration with this method is at 10 - 7 magnitude.
90. This paper describes an absolute method for the calibration of the complex cur-rent ratio of the inductive current divider and the current comparator.