ejector造句
61. The influence of primary flow and secondary nozzle geometry on ejector effect and thrust was investigated, and the approach to increase thrust of rocket ejector was found gradually.
62. Note that die length of ejector pin contact with the mould plate is kept to a minimum by incorporating a clearance diameter hole in the mould plate.
63. Hydraulic drawing-core mechanism was adopted for two-side of inner-sinking in the die casting die, and pre-resetting mechanism was set to avoid the interference of core slide with ejector pin.
64. Ejector seat levers can only be used once, and their consequences are significant and irreversible.
65. Suitable sizes of push-back pins may be selected from a standard ejector pin range.
66. FIG. 2 is a bottom view of the fluid ejector from FIG. 1C.
67. The ejector grid is that part of the mould which supports the mould plate and provides a space into which the ejector plate assembly can be fitted and operated.
68. The issue that high hot and high speed wake had affect on the ejector plate and protection-piston of the launch vehicle was also investigated.
69. An ejector arm on the coffee brewer engages an ejector blade on the lower cartridge shell and biases the lower coffee shell downwardly to eject the used coffee cartridge into a used cartridge bin.
70. In ejector and ramjet modes, working over a wide Mach number range is very important for the RBCC inlet, so the 2D RBCC inlet should be variable-geometry.
71. However, the compressed air pass the same large area of Laval nozzle in the traditional vacuum ejector all through the working process, so its large shortcoming is high compressed air consumption.
123