coating造句
151 Application process of blade coating and abrading putty before coating automobile body are introduced. The categories and application methods of putty used before repair coatings are described.
152 The thermal protection mechanism of three layer for coating material under heating process was discussed, the conservation equations which reflects difference function was established.
153 The new water-based mold coating for resin-bonded sand mold and core for aluminium castings has been developed.
154 The protective coating on aluminium foils packaging for medicine was formulated with thermosetting acrylic resin, pyroxylin.
155 Silicone alkyd coating are based on either the reaction product of a silicone intermediate and an alkyd resin, or a cold blend of silicone resin and compatible alkyd resin.
156 WF40 coating is the epoxy glass flake coating with thermal expansion efficient close to that of base metal and high resistance to the thermal shock.
157 Polish is the finish on the cards and membership cards to make products in surface coating.
158 The coating requirements and the selection of coatings of chrome plating plastics are introduced.
159 A polysulfide rubber modified epoxy water-proof and corrosion protective coating has been developed, which is used for water-proofing and corrosion protection of metals and concrete.
160 Comperhensive summary on the application of coating self - hardening resin sand is presented.
161 XRD, SEM, TEM and HRTEM were applied to analyze the phase composition and microstructure, as well as crystal defects in the RPS TiN coating.
162 Do not apply to nonstick cooking utensil. May cause surface coating to peel.
163 Rough and half coating surface in lower ammonia and deionized water concentration.
164 The results show: Compared with scratch and indentation tests, the repeated impact test is more sensitive to the configuration and structure of the coating.
165 Apply a thin coating of petroleum jelly or chassis grease to the exposed surfaces of the battery cable terminal clamps and the battery terminal posts.
166 A new procedure which is called double suction straining coating method for the preparation of gas-liquid chromatographic stationary phase was reported.
167 This article is concerning the lightweight microwave absorbing coating containing carbonyl iron powder ( CIP ) .
168 The material of shading cloth basically has 3 kinds character: One kind is the front is primitive grey, but chromatically , the reverse side is PVC coating.
169 When use, should put among mortar wing epispastic board, as expand resilient coating.
170 In this paper, the performance of the airtightness for vacuum coating equipment, the characteristics of leak detection with Helium Mass-spectrometer and the leak detection system are described.
171 The effects of mica on brushability in EPC and coating layer on the wettability of liquidized product of foam pattern were investigated.
172 A special coating technology for product oil tanker is introduced.
173 Produce those who taste quality to selective examination to coating recently specification, partial product is put in a few technical quality problems.
174 A method of applying the coating to the piston skirt is also disclosed.
175 Mechanism of low gloss- producing, structure of coating layer, manufacture and development of matte and dull coated paper were described.
176 With a novel pattern or pattern coating hollow seat and back, tailored to your indoor furniture.
177 This problem can be solved a bactericidal and anti-corrosive coating on the walls of the wells.
178 Phases constitution, microstructure and element distribution of the coating were studied by X-ray diffraction(XRD), scanning electron microscope(SEM) and electron probe microanalysis(EPMA).
179 The synthetic product poly-DMDAAC was subsequently prepared based on free radical solutions polymerization, which was then applied as cationic additives in ink-jet paper coating.
180 CONCLUSION The future of aqueous dispersion coating is good and it needs deeper study.
12345678