abutment造句
31. He also discussed on SPSRSFF application for stability analysis of arch abutment.
32. Overlength isolated working face reduces the superposed influence of abutment pressure on isolated working face.
33. Accordingly, the distribution of abutment pressure on the block coal pillar is measured at working face with a steeply inclined seam of the12010 face, NO.
34. Jointless bridges consist of integral abutment. The beam, abutment and flexible pile serve as an interal system.
35. Objective: To explore the method of applying variant pontic to fixed bridge with tilted abutment without common path of insertion.
36. An effective type of retainer, possessing retention, support and a splinting action between multiple abutment teeth, is a double crown known as the telescope retainer.
37. The surface quality of concrete and abutment is one of the important indexes in quality assessment.
38. Abutment stability problem is very important in the design and study of arch dam.
39. This paper illustrates the line pattern determination method of the main cables after the abutment shift, the length calculation of the main cables and their installation process.
40. Conclusion: Electrotome gingivoplasty have no negative effects on periodontal health of the abutment teeth with PFM crowns.
41. Casting clasp between teeth ( CCBT ) is set up between buccal arid lingual embrasure of abutment teeth.
42. Finally, travelling wave effect decreases the longitudinal seismic effect of the abutment pier and increases that of the other pier, but it is not noticeable influence on the lateral seismic effect.
43. Objective To evaluate the effects of GLUMA desensitizing bonding system in desensitizing hypersensitivity of vital abutment.
44. Engineering practice of the abutment - slope system verified effectiveness of the multi - reinforcement.
45. Objective The effect of clasp on the health of abutment teeth.
46. Whereas the fault, low wave speed band and deep crevice in left abutment of foundation can always be the hidden defect of the project.
47. With the recent development rapid in port construction in China, some large size abutment pier with high level piles were built, including liquefied petroleum gas berths and oil berths.
48. Using the formula proposed abutment locations to determine the consult position and the stable angle of slope.
49. Combination qualitative and quantitative method, studying synthetically on the abutment slope off-load zoning.
50. Objective To evaluate the abutment periodontium condition after restored with the distal - extension attachment dentures.
51. Position the power and ground feedthrough or abutment pins so that they align with corresponding pins in other cells.
52. The unstable the right abutment of Danjiang arch dam analyzed under the thrust from arch dam.
53. Located in the northeast of China, there is an overbridge crossing above an expressway. Its right abutment is seated on a rock-masses slope with low carrying capacity.
54. Stress shell, which bears and pass load of overlying strata, is primary supporting body. The stress in skewback of stress shell forms abutment pressure of surrounding rock in vicinity of working face.
55. This paper specified the material filling, range filling, sequence construct technique, and quality control on back-filling at abutment , and the importance of it.
56. Bridge support is a force transfer device installed at support of bridge structure with pier (or abutment). It is a kind of the structural parts that can bear high pressure.
57. The paper mainly studied the stress characteristic of the skew slant leg rigid bridge without abutment.
58. By virtue of an aid station based on the abutment central pile, "comprehensive formulas for the layout of curves "is used to calculate the crossing angles of every pier or abutment.
59. Because the finishing cut is continuously affected by the abutment pressure in front of the face, its maintenance is much more difficult than that of the ordinary coal entry.
60. The influence to stress of skew arch bridge was studied by changing the abutment torsional stiffness and width-span ratio.
123