crankshaft造句
1. The engine had a broken crankshaft.
2. The camshaft rotates in phase with the crankshaft, but at half its speed.
3. All moving parts, apart from the plain-bearing crankshaft, use needle roller bearings to help it rev freely.
4. When checked for straightness, this crankshaft was found to have little or no distortion.
5. Remove the crankshaft oil slinger.
6. Heavy crankshaft is the key component of gas engine.
7. This paper describes a method for crankshaft stress calculation.
8. The crank is an offset section of the crankshaft.
9. Undersize crankshaft main bearing journals.
10. The state of the art of spheroidal graphite crankshaft is introduced.
11. Applying the slender crankshaft, the level rolling bearing technology, and lower viscosity refrigeration oil, increased the mechanical efficiency.
12. Crankshaft is a very important component of large marine engine and its key component is crank.
13. The crankshaft bearing is one of the most important friction pairs and moving parts of the internal combustion engine.
14. When obtain piston position signal from Crankshaft, Top Dead Center Sensor and Crankshaft Position Sensor tend to be integrative in structure.
15. Similarly, in the crankshaft journal and crankshaft bearing clearance measurements, they can draw on such skills.
16. The crankshaft checked in dynamic equilibrium ensures the enggine running smothly.
17. FAW TOYOTA engine company crankshaft product line uses carbide tool and MQL technique to process crankshaft oil holes.
18. Pry the crankshaft forward , position the dial indicator to zero.
19. The bearing loads and crankshaft fatigue strength are calculated according to the principle of a simple beam.
20. The Corrado's supercharger sits alongside the transversely mounted engine and is belt-driven off the crankshaft pulley at 1.66 times engine speed.
21. Until six weeks ago I had first class service, then, suddenly, the crankshaft snapped.
22. The test results show that the misfire malfunction simulation device can run reliably and have an apparent influence on the engine crankshaft instantaneous speed fluctuation.
23. The motion of the rotor can be balanced completely with rotating counterweights attached to the crankshaft.
24. The software mainly processes the rotate speed signal of the crankshaft and camshaft position signal to export ignition control signal.
25. The computational process and calculation result prove the feasibility and validity of this method for a crankshaft system.
26. The cycle begins at top dead center (TDC), when the piston is furthest away from the axis of the crankshaft.
27. A new ion S-N-C co-diffusion plus Ar-bombardment treatment process for the Starer crankshaft was introduced, with a specially designed attachment to control the deformation during the process.
28. And then, transfer them into equivalent amount of unbalance by the balancing method of six cylinders crankshaft to six ridding planes.
29. Each pair(of cylinders) drives one crankpin, via two connecting rods, and the front of the crankshaft is geared down to a slower-running propeller.
30. Connecting with the actual production process , crack formation in ZG 35 CrMo crankshaft is analyzed.
1234