rolling mill造句
31) Working condition of roller rings used in finishing roll sector or pre-finishing roll sector of high speed line or rod rolling mill production line is extremely vile.
32) The structure of rotary joint used for complete set of aluminum plates rolling mill are analysed. The detail introduction of modified structure is given.
33) In this paper, PCA and statistical control chart have been used to detect process operating faults on an industrial rolling mill reheating furnace.
34) The first repair of R2 rolling mill housing frame is carried out during the revamp of Angang's 1700mm hot strip line so as to save capital investment and reduce time.
35) The function and character of logical module LOGO! For SIEMENS is introduced in dais paper, explaining thorough its application in continuous-casting rolling mill spray device.
36) The selection control system is the critical procedure in the final line of cold rolling mill.
37) Automatic velocity control system for the continuous tandem cold mill let the rolling mill work continuously by using the looper to keep the uncoiling operation separating from the rolling process.
38) Presently, the calculation of rolling force and energy on rolling mill has large enough error no matter what theoretical model, empirical or semiempirical model is used.
39) The structure of rotary joint used for complete set of aluminum plates rolling mill are analysed.
40) The contour and microstructures of the carbon or quartz ceramic rollers used in the continuous annealing furnaces in the Silicon Steel Sheet Mill and the Cold Rolling Mill are analyzed.
41) A constant force hybrid adaptive control system is designed for four rollers cold rolling mill to ensure that strap steel force is constant.
42) Medium plate rolling mill is the hardcore of a medium plate plant, and it is important to monitor operation conditions of the rolling mill on line.
43) Township enterprises have Xinzhou Rieter Ltd. and factory system, quartz plant, rolling mill, furniture factory.
44) This new type pilot cold rolling mill has been used successfully.
45) It is a general issue that the meshing force between the gears in the rolling mill herringbone gear stand is not sufficient.
46) Through axial movement of work roll and cooperating with hydraulic bending roll technology, WRS rolling mill can increase plate shape controlling capability and can improve edge thinning of plate.
47) Special instrument is used for measuring rolling force of rolling mill, its transducer is made of solid piezomagnetic alloy material and the overload capacity of the instrument is high.
48) At the same time, to increase the rolling reduction, reduce rolling passes and improve the productivity of rolling mill.
49) In the cold rolling mill, coil open-book will open the machine, and then strip the introduction of a rolling mill stand even with volumes thin.
50) Strategy on roller replacement at a fully automatic continuous rolling mill, together with its equipment inspection and replacement cycle in production management, has been studied and discussed.
51) The article describes the constitution, structure and calculation of two - h rough rolling mill.
52) Flying shear is one of key equipment on rolling mill.
53) The solutions to above the problem are setting an accelerated controlled cooling device behind the finished rolling mill and adjusting proper cooling parameters.
54) Pull rod is the main bearing part of compact rolling mill and usually occurred abruption accidents.
55) The mill housing with short stress path and high rigidity laid H/V alternatively, the start-stop flying shear and the cold bed with optimum design have been adopted by the continuous bar rolling mill.
56) The requirements for a computer control system used for a rolling mill, especially for hot strip mill,[www.] are the high speed control cycle and high speed communication between controllers.
57) The calculation for the caster angle of cardan shaft in the skew rolling mill is more complicated than that in general rolling mill.
58) Ring rolling mill is the core equipment of the rolling technology.
59) For a typical rolling mill, the work rolls are driven by universal joint drive shafts.
60) By the simulation for the transient responses of the upper shafting in the main drive system of 1150 rolling mill, the computer programme is proved to be effective.
123