monostable造句
(1) Comparison of input signal and monostable pulse width.
(2) Gates IC1c and IC1d make up the monostable along with timing capacitor C1 and resistor R2.
(3) The monostable is an edge-triggered device which resets the timer every time the mercury rolls on to the switch contacts.
(4) An ordinary push-button switch triggers the monostable whose output goes from Logic 0 to 1.
(5) A twin monostable circuIt' supplies the data and strobe signals.
(6) Secondly we changed the sampling mode, using dual monostable multivibrators to select the focusing window, which solves the sampling drift problem raised by SCM break.
(7) The tunnel diode monostable circuit with non-linear biasing plays an important role in millimicrosecond pulse techniques.
(8) By using a monostable multivibrator consist of 555 timers, a circuit of threshold processing PWM signal's duty cycle is proposed.
(9) Based on the monostable circuit, using the IC NE555, a kind of hot water circulation automatic heat preservation system was designed.
(10) A continuous input pulse train triggers monostable circuit, and a control signal modulates the threshold voltage.
(11) A continuous input pulse train triggers the monostable circuit, and a control signal modulates the threshold voltage.
(12) The design principle of monostable flip flops is investigated in this paper.
(13) The digital realization of monostable circuit and extraction of bit-synchronous signal with digital phase lock loop are also introduced in detail.
(14) Here the 555 timer i.c. is used in conventional monostable mode but with a control voltage applied to pin 5.
(15) Connecting a diode in parallel with the capacitor C converts the astable multivibrator into a monostable multivibrator with one stable state.
(16) It is a member of the multivibrator family the other two of which are the monostable and the astable.
(17) Based on the detail analysis of PMA of VCB in existence, a novel PMA of VCB, which is monostable, has two coils, is proposed.
(18) A tester is made based on the typical circuit of the monostable trigger made of 555 timers. It operation principle, coupling way and usage are analysed in great detail.
(19) This paper brings forward a method of threshold processing PWM duty cycle by employing monostable multivibrator.
(20) By the STB signal of the computer to trigger the repeatable triggered monostable circuit, the printing channel which is first called is opend and others channel is blocked at the same time.
(21) In addition, the reason for affecting the timing precision of the monostable circuit is analyzed and the solution of this problem is put forward.
(22) The synchronous signal of MC1311 CMOS camera is shaped by monostable trigger 74LS221. The data are stored in AT24C02, protected in the case of electricity loss.
(23) The investigation shows that when the biased input is vanishing, the relaxation rate has different dependence in monostable and multistable cases.
(24) This paper brings forward a method of threshold processing PWM signals duty cycle by employing monostable multivibrator.
(25) The accuracy of delay or timing is not sensitive with monostable trigger circuit since electrical elements have influence on it.
(26) At the same time the principles of triggering pulse to the three-phase thyristors is discussed, and a way using monostable multivibrator to produce the pulses has been given below.
(27) The test shows that the vacuum circuit breaker with monostable permanent-magnetic operation system could fully reach the operation requirement by the electrified railways.
(28) The switch circuit is composed of an emitter-coupled trigger circuit, an integral delay circuit and a monostable circuit.
(29) It is found that the system will be in monostable state or bistable state, which is controlled by the competition between the uniaxial anisotropy and the exchange anisotropy of the system.
(30) According to characteristic of computer control system of electrohydraulic motion platform, the paper designs a surveillance protection system by the monostable trigger.
12