cutoff造句
31. The chromatic dispersion, cutoff wavelength, mode field radius and tolerance of a structural design of dispersion-flattened single-mode fiber are calculated and discussed.
32. The influence of the ridge position on the cutoff wavelength of the dominant mode in asymmetric single ridge waveguide is analyzed by finite difference method.
33. The causes are analyzed. A new control approach is presented with a "local strain compensation" and a low cutoff frequency inertial link feedback in place of the differential one.
34. Its parameters can be regulated by keyboard in order to control amplification and cutoff frequency step.
35. This paper describes the application of finite element method for obtaining the TE mode′s cutoff wavelength and the field pattern of symmetric quadruple-ridged rectangle waveguide.
36. A power cutoff saw with carbide blade is recommended for high volume cutting.
37. The sensor programmable variables include channel sample rate, gain, offset, and filter cutoff frequency characteristics.
38. In this paper, a new signal processing technique, cutoff frequency technique, is developed on the base of SSP.
39. The amendments provide several other sanctions, including a cutoff of federal highway funds.
40. Accordingly, with these factors taken into account and optimized, we developed a wide frequency bandwidth current transducer with a lower cutoff frequency 12kHz and upper cutoff frequency 28MHz.
41. Because the HF horn had a very large mouth diameter it had an inherently low cutoff frequency.
42. In this article, the influences of the mode field diameter, the cutoff wavelength and the relative refractive index difference on the OTDR curve are also verified.
43. The paper computes the cutoff wavelength and field pattern at different ridge positions in asymmetric single ridge waveguide and L-shape waveguide.
44. Burr Oak Tool Inc. produces three types of cutoff machines – two process coil and straight tubing, while the third processes coiled multivoid (micro channel) tubing.
45. The paper computes the cutoff wavelength and field pattern at different ridge positions in asymmetric single ridge waveguide and L-shape waveguide. Some computational data and figures are presented.
46. It illuminates that the main part which transit cutoff region is high-frequency ponderance .
47. The present technique is a new thin cutoff wall construction method by modifying the original method as to use flat drill bit instead of cross bit and adopt positive and negative circulating system.
48. The effects of the air holes on EDHALFs' cutoff wavelengths, mode field diameters and the gain coefficients of fiber amplifiers are studied.
49. The cutoff wavelength can be adjusted by adjusting the ridge position.
50. The method of lines is used to compute a variety of mode cutoff frequencies of a grooved waveguide loaded with E plane dielectric and ferrite slabs.
51. Ginny was born around 1981 -- most likely before Halloween,[http:///cutoff.html] given the presumed Hogwarts cutoff date.
52. Any proposal for a negative income tax must have at least three elements-an income floor, a marginal tax rate, and a cutoff point.
53. A new deep trench termination structure is proposed, which can simultaneously improve cutoff frequency and output power of silicon bipolar transistors.
54. Optical fiber cutoff wavelength is one of the important design parameters.
55. Low-voltage circuit-breakers of rated frequency 50Hz may be used in the circuit of 60Hz while at 60Hz the cutoff current is higher and the breaking time is less than that of at 50Hz.
56. The numerical calculation methods of the cutoff wavelength and mode field diameter are described in detail.
57. And there is only one even mode having zero cutoff frequency, i. e. , there is a single mode area.
58. The cutoff does not have to be taken to infinity.
59. The line array FPA has much higher space cutoff frequency and wider FOV relative to the staring system.
60. Cutoff Values for Testing: How Great the Difference True and the False Makes Them Distinguishable?
123