workpiece造句
91. In NC turning, it is difficult to reach identical height for lathe tool and the axis of workpiece, thus it produces tool setting error.
92. Abstract: A simplified pattern making process that workpiece is reproduced to make casting directly is introduced.
93. The contact zone between roller and workpiece and its contour's definition are the cruxes of establishing the FEM mechanical model.
94. Through analyzing a simple rotary cutting device for regular polygon, the forming principle was introduced, and the equation of knifepoint relative to workpiece was established.
95. Outer circle centerless grinding is a non centering grinding. It's orientated by outer circle of workpiece itself and grinded by support of a supporting plate.
96. A simplified pattern making process that workpiece is reproduced to make casting directly is introduced.
97. The Influence of three grinding fluids on grinding force, metal material removal rate, surface roughness of ground workpiece, and the extent of grinding bum were investigated in this paper.
98. An auto - controlling system of arc length for AC - TIG welding with half-cycle arc voltage (workpiece positive) as a sensing signal is introduced in this paper.
99. The sampled data of a workpiece to be measured is obtained on a universal tool micr...
100. The chamfering performed to deburr the edge of a workpiece after the machining process is necessary to obtain workpieces with a certain quality.
101. The synchro accuracy of two spinning wheels of spin forming machine can he obtained by using the synchro system of valve controlled pump-motor, therefore the quality of workpiece is ensured.
102. Is rigidly fixed to machine the workpiece or T-slot machine workstations to complete.
103. A housing with a recess for the introduction of a workpiece accommodates a clamping mechanism with a crown gear that is positioned and driven at its circumference.
104. Comparative measurements of percentage of silicon on the surface of workpiece by powder-mixed electrical discharge machining (EDM) were carried out.
105. Under the condition of a minor space, the utility model enables a flat section workpiece with a light section to change from horizontality into erectility under the function of screws (3).
106. The studied results show that the radial dimension of keyhole increases with laser power for partial penetration, while it is nearly unvaried when the workpiece is fully penetrated.
107. Both theoretical ana- lyses and experimental results show that the taper and axial deviation of the workpiece are accurately measured, and thus the measuring accuracy can be improved efficiently.
108. With the rise of the grinding temperature and the increase of grinding force, the deformation of the grinding wheel and workpiece increased. Thus it resulted in the increment of contact length.
109. Diathermanous furnace inductor, is also know as through-type inductor, it is long or short according to the length of heating workpiece and the diameter of the workpiece.
110. For the vision of assembly robot, realizing the invariant shape recognition of mechanical workpiece is the base.
111. If the workpiece feed speed is reduced, the friction coefficient will increase.
112. In this paper a new method was set up to investigate the indentation process through computing average potential and radial distribution function(RDF) of workpiece at the same time.
113. A new mechanical model of the vibration between the workpiece and the main spindle caused by the grinding wheel unbalance is proposed in this paper.
114. In the process of EDM, dielectric medium has remarkable influence on material removal rate, surface quality of the workpiece and relative electrode wear ratio.
115. The yield strength of the agglomerated material due to extrusion increases in the vicinity of cutting edge. It makes contact stress increase, and eventually results in microcrack on workpiece surface.
116. The state of tool workpiece contact zone in Electric Hot Machining(EHM) is different from that of conventional cutting.
117. Meanwhile, it finds out electroanalysis parameters influencing workpiece size precision and surface roughness.
118. This can calculate the accurate size of the blank be used in the expanding of circular section workpiece with discretional curve as its axes.
119. The workpiece is clamped in position, and cutter is located against the setting block, which provides setting or cutter position and depth of cut.
120. The conductive body can keep elastic contact with the welding workpiece under action the elastic piece.
123456