weld造句
211. Can you spot weld a tube to a sheet metal?B: Yes, you can, with a special shaped electrode.
212. This indicated that the fracture had initiated at the unfused butt weld in the longitudinal stiffener.
213. The paper described the reliable weld seam tracking system based on dynamic mask match spirally tubes.
214. Indicates a weld in a flanged corner groove. Lines will elongate when height is increased.
215. The elements can be put together in various ways. For example, a lap join may be held by a fillet, plug, or slot weld, and and a tee joint by a fillet or groove weld.
216. And the weldpool oscillation frequency is the characteristic parameter of the weldpool oscillation pattern and the weld penetration.
217. However, as the chemistry, diffusible hydrogen level of the weld metal, restraint or section thickness increases, the demand for preheat also increases.
218. It is of great significance to fast weld and repair damaged parts in electroless and gasless field.
219. X-ray real time imaging for weld inspection using the X-ray industrial television detecting system...
220. Abstract: A cavity is made on both sides of weld bead.
221. UNQ butt welders can be connected to the straightway and ball joints of low-carbon steel, copper and aluminum, and are widely used to weld rings.
222. A computer - aided system for testing and analyzing weld thermal cycle is presented in this paper.
223. Intorduction of air hole weld defect in Skelp connection Weiding of HF welded Steel Pipe Mill, analysis of the cause of formation, and bring forward means of troubleshooting.
224. Weld visual Inspection for Product Acceptance is conducted after all processing is complete and is a part of the final Product Acceptance Process prior to release to the External Customer.
225. This article introduced the experiment of residual stress in flat tubeplate head of large scale fuel boiler that was manufactured by cold rotary extruding and butt weld.
226. Recognizing that the solubility of gas is greater in the liquid state than in the solid state, the subject of weld porosity is relevant to fusion zone discussion.
227. The influence of weld heating on microstructure of heat affected zone was investigated in this paper.
228. In CO2 gas metal arc welding, the difficulty hi seam tracking by pendular arc sensor is how to attain the tolerance signal of weld joint.
229. The arc blocking device has rapid reaction and is suitable for various weld operating conditions, particularly suitable for the operation above the ground.
230. The weld metal showed very good toughness at low temperature, and dominant microstructure of acicular ferrite.
231. According to the working order, make welding program, choose welding tools and adjust the fixture. Weld profiles based on the policy on first-in-first-out.
232. Learn how to use a handheld grinder to grind down and polish weld to the height of the surrounding metal structure free power tools video.
233. It was found that impact toughness of weld metal was maximum using carbon arc air gouging, and it was minimum using acid backing.
234. There are reactor coolant system weld issues, they're used and they're getting primary water stress corrosion cracking.
235. To put the ideas into practice, we must weld the cadres together and encourage them to go into action; this comes into the category of "using the cadres well".
236. Standard weld is autogenous weld across end (A.W.A.E.). Sanded after weld.
237. The backside image of molten pool recognizing the weld penetration status has been acquired by the vision detection method of applying an external illumination source and an appropriated filter.
238. As-welded tube will have the residual weld bead of metal protruding into the ID of the tubing.
239. Overview This order applies to magnetic material and weld Magnetic particle inspection.
240. The micro-structure and mechanical properties of X65 pipeline steel jointer weld were studied.
12345678910