rotor造句
91. The results show that , the ratio of the output power of vaneless counter-rotating turbine can reduce 2.6% at the same turbine efficiency when the low pressure rotor curves positive.
92. The invented generator comprises rotor on shaft fixed in body case as a rotatable bearing, and stator (8).
93. This paper briefly describes the principles of balancing and correcting for low-speed spinning satellites that work as rigid rotor on ver- tical dynamic balancing machines provided with hard supports.
94. In this paper the motion of a torque - free asymmetric gyrostat with a mass - eccentric rotor is discussed.
95. A method of self - sensing rotor position of magnetic bearing is introduced in this paper.
96. This paper presents the analyses of the aerodynamic interaction between the two rotors of a coaxial rotor helicopter and the change of interaction with the increase of the advance ratio.
97. The shaft of the turbine is coupled to the rotor of the generator.
98. A method is given for the calculation of the stability and the control of a helicopter with hingeless rotor under lateral gust.
99. The exact rotor position is required while a permanent magnet brushless servo motor (PMBSM) is under commutation and control. Howere, position sensors have some fatal defects.
100. Rotor wing plane is a new concept of aircraft, and is the combination of rotor aircraft and fixed wing aircraft.
101. On the Main Rotor system, they went with an all metal Swashplate with adjustable lower Swashplate ring so your Beam would never develop a sloppy feel.
102. The effect of mixer synchronous rotor shape on the dispersibility of nano- fillers and physical properties of NR vulcanizate was investigated.
103. Since the rotor is fed by a invertor, the waveform supplying the stator can be affected.
104. While the characteristic of the control chip TMS320F240DSP, the sensors for stator current and rotor speed detecting and the corresponding data interface processing were also presented.
105. Based on analysis of rotor current of the generator under both load and empty load conditions, derives the mathmatical expressions of direct-current component of rotor current.
106. Finger is the important component of automobile engine rotor, whose centrifugal deformation is the key element affecting engine interstice.
107. Once the product is ex-work, the motor load condition shall be judged initially based on the rotor voltage and current, and liquid resistance will be ready.
108. The crankshaft makes three rotations for each rotation of the rotor.
109. The computation results of rotor winding ventilation of a 125 MW air-cooled turbine generator with sub - slot had been provided.
110. The network, the rotor speed models are also introduced, and the double synchronous speed mathematical model has been deduced and set up in this paper.
111. The methods using rotating vector, carrier frequency excitation and heterodyning, tracking observers for rotor position estimation are discussed.
112. After every day of flight, it is also a good practice to check ball joints on the rotor heads and rotating portion of the swash plate. Replace overly loose ball links immediately.
113. In this paper, a microcomputer-based frequency multiplication and full period sampling method is introduced, and an application of this method in dynamic balancing of rotor is also introduced.
114. Starting with the analysis of mutual excitation of different degrees of freedom, the physical nature and influence factors on rotor dynamic instability are revealed.
115. The experimental result has practical significance for correctly using the twin - rotor turbojet.
115.try its best to collect and create good sentences.
116. The nonuniform induced velocity distribution on the rotor disk is derived from the fixed vortex theory.
117. In order to obtain the rotor angular position and velocity information, a state-observer-based algorithm was presented to demodulate output signals of the magnetic encoder.
118. As a prospect , a kind of new wind turbine generator based on coning rotor is discussed.
119. ZT-3 rotor test bed in Department of Mechanical Engineering in Southeast University is a DC motor centered open-loop control system, which speed is controlled by regulating the regulator manually.
120. This thesis use ADSP 21161 to receive data , preprocess data, and identify armature and rotor parameters.
12345678