shear造句
121 Direct tensile, acceleration, and shock wave tests belong to the tensile test group, whereas adhesive tape, direct shear, peel and scratch tests belong to the shear test group.
122 A stiffness method for determining the response of shear lag effect on box girder is presented.
123 The MAO layer exhibits good shear resistant for there is no obvious peeling during scratch test.
124 The rear cone decentration and compact leg tilt can both result in a phase shear and twist on the optical field, and lead to phase jump and tilt along the misalignment direction.
125 Using these formulas and a 1-D LDA, mean square value of 2-D turbulent velocity fluctuation and Reynolds shear stress have been measured for water flow in a square duct.
126 The results show that strength of NEPE solid propellant under multi-axis stress state is related to strain; octahedral shear stress nonlinearly increases with the average main stress.
127 The type of shear connectors selection test and full-scale model test for the anchorage zone segment of Jintang Bridge, which is under-construction, were the project background.
128 The volumetric strain induced by shear stress is shrinking at first, then dilating later under triaxial compression test conditions, of which the value is determined by density and stress state.
129 Shear Angle research is one of the basic problems in metal cutting theory.
130 Every spring they shear off the sheep's wool and sell it.
131 The sheathing - to - framing joints are the primary influencing factors of the light wood - framed shear walls.
132 The shear strength of CFST columns was correlated to the axial force ratio and the shear-span ratio.
133 Finally, the shear correction factor for each element was estimated and the global response corrector was calculated by the incorporating shear correction factor.
134 Reasonable design of shear connector need availably control of horizontal shearing force between steel webs.
135 Normally the shear velocity is about half of the compressional velocity.
136 The critical starting condition of silty clay has a non-linear relationship with shear strength and water content.
137 Within this dissertation, both thermodynamical and hydrodynamic effects of shear are considered, for the first time, in the modeling of the shear-induced phase behavior of binary polymer blend.
138 The optimal time which produces the best rheological properties of modified asphalt depends on the blend composition and on the shear rate used.
139 The transformation is due to the shear strain imposed on the specimen by ECAP.
140 The results show that the methods developed in this paper are reliable, which can reasonably simulate the seismic collapse process of reinforced concrete frame structures with shear type deformation.
141 Stability method that based on the FE (Finite Element) stress analysis of slip surface and the shear strength reduction method are two principal methods of FEM slope stability analysis.
142 All the firstling males that come of thy herd and of thy flock thou shalt sanctify unto the LORD thy God: thou shalt do no work with the firstling of thy bullock, nor shear the firstling of thy sheep.
143 The antiplane shear problems of collinear cracks at the interface of dissimilar anisotropic materials aredealt with.
144 On the above basis, an empirical model was developed for correlating the erosion rate with the oil temperature and shear stress.
145 White-light scanning technology was used to test the wrinkle characteristics of a square planar film reflect-array which is under pure shear force.
146 The direction of maximum tension moves asymptotically toward the direction of the shear.
147 The particle route method is produced for the shear force diagram drawing of multi-span beam based on the geometric principle of the force addition.
148 The distribution curve of workpiece temperature induced by the shear heat source is obtained.
149 Results from undrained triaxial shear tests show that this model can well describe the stress-strain characteristics of soft clay.
150 The delay was correlated to the development of shear lips crack surface.
123456