receiver造句181. The code multi-path error is reduced from tens of meters to sub-meter and the C/A code GNSS receiver positioning accuracy is thus greatly improved.
182. The receiver section is designed using the MAX3748 limiting amplifier (LA) and MAX3744 transimpedance amplifier (TIA).
183. One factor is that unlike the old line feed antenna, which was hanging by itself, exposed to the tropical elements, the multi-beam receiver is located inside the distinctive-looking Gregorian dome.
184. The bankrupt must also assign all of his patents to the receiver.
185. Each sensor node makes a local decision according to the characteristics of sonar receiver and sends it to the fusion center node.
186. In order to enhance the saturated optical power, the transimpedance of receiver module is replaced by the one with DC cancellation circuits, and then it is up to –1dBm.
187. The key technology for the whip-loop antenna, receiver, signal-processing platform and time-division is described in detail, respectively.
188. Interacts and cooperates with all sub section in the storeroom, merchandise receiver, merchandise deliverer and with receiving clerk.
189. Channel vector is estimated only by utilizing pilot channel in 2-D RAKE receiver conventionally. The estimation error will be large when the power of pilot signal is weak.
189. Wish you will loveand make progress everyday!
190. In OFDM systems, the receiver must acquire the ChannelStatus Information ( CSI ) to equalize the frequency - selective fading.
191. The super - regenerative receiver is the one of the many wireless data transmission systems over short distances.
192. The PMD-induced pulse broadening may cause degradation of receiver sensitivity and has negative effects on the power spectrum of received signals.
193. Under weak signal environments, bit synchronization is very important and difficult in GPS receiver design.
194. Simulation results show that the design is efficient with the soft-failure of gyro, accelerator, GPS receiver and Doppler radar.
195. This paper presents an all digital timing recovery loop in a single chip for DVB-C receiver.
196. The vehicle Autotracking and Positioning System is comprised of a GPS receiver, a digital map and a embed system.
197. The operating distance of a laser radar system is determined on pulse energy, pulse width, beam divergence angular, atmosphere attenuation, target reflection, receiver sensitivity and so on.
198. Corresponding to public key cryptographic algorithm, it can save energy consumption because the receiver can aggregate cryptograph directly instead of obtaining explicit terms.
199. In the receiver, information is demodulated by analyzing synchronization error.
200. Spurrier might have to call on his star wide receiver more frequently down the stretch.
201. Low-noise amplifier(LNA) is one of the most important modules in the front of the RF receivers, it is of great importance in the performance of RF receiver.
202. There is no caress more lovely and warm than a love letter, because it makes the world seem very small, and both sender and receiver become like kings in their own kingdoms.
203. In this case, which seems to violate the "no shield current" rule for receiver circuits, the concentric cable is not used to shield the center lead; instead, the geometrv produces cancellation.
204. This paper introduces improvement and design of the five key modules of the French LP23K radar receiver.
205. The positioning accuracy of avigation of GPSMAS depends on the positioning accuracy of GPS receiver as well as designed station accuracy of seeding area.
206. The receiver includes the choice of photoelectric detector and receiving circuit.
207. The design of the resampling filter is a key technique for symbol synchronization in all-digital receiver.
208. This receiver is analyzed in theory and simulated in IEEE CM3 multipath channel. The results show that it has a better bit-error-ratio performance compared with a conventional ATR receiver.
209. In the receiver, a novel digital method is proposed to demodulate the 2RC CPFSK signal.
210. It sets up the asynchronous receiver using MQ LLM APIs.