pid造句
61 Be dead against the lack of the PID control, this paper discusses the discrete-time model reference adaptive control methods applies to the motor drive system.
62 The measure and benefit of inverter PID closed-loop control reformation were introduced.
63 After that, the active vibration control model was built according to the datum and results to analyze the affect to control effect of sample time and PID parameters.
64 This method can optimize the PID parameters by using the quadratic performance index and identifying the controlled object parameters on line.
65 Simulation results demonstrate better performance of this neural fuzzy controller in comparison with those of the nonlinear PID and traditional fuzzy algorithm.
66 PID control based on iterative control compensation is used in position control part.
67 During the shakedown period, the authors derived formulas to calculate the above set parameters and proposed a new concept to tune the PID controller.
68 According to the requirement of smelting process for electrode control system, a fuzzy adaptive PID controller is presented and has been applied to practical control of electrode successfully.
69 PID controller has simple algorithm, good effect. thus it is widely applied in commercial run control systems on the chemical industry, metallurgy, machinery, hot working, light industry and so on.
70 In chapter 3, the PID controller parameters of an aeroengine model is optimized by MOEA NSGA - II.
71 The variable structure PID control is accomplished at the local using80C196SCM, and the collective monitor and dispatching of the far-end control computer center are achieved.
72 Finally, the application of HILS approach in the eddy current dynamometer test bed and the PID control algorithm optimization is given.
73 The system adopts non-proportion radial homing control algorithm with modified PID blind zone, and its control capability is great.
74 Fixed resistor load and on-site welding are studied respectively, the feasibility of fuzzy adaptive PID algorithm is verified by the steady state and transient's study.
75 To modify expanding response curve method(ERCM) for PID, an open-loop recursive solution to ERCM is proposed, which simplifies the parameter setting of PID.
76 PID theory decides the controller generally based on past information and set point of the output.
76try its best to collect and create good sentences.
77 The study demonstrates that the control combined with Fuzzy and PID can decrease the steady-state error.
78 Self-tuning PID control parameters results virtually have no overshoot and get stability in short time, and have less oscillation at the set target angle value.
79 According to the characteristics of combustion process for drum boiler with the direct firing of pulverizing mill, fuzzy PID algorithms have been proposed.
80 As a result of it, the control algorithm in the article enhances the dynamic quality of large-delay object, and excels PID control in the anti-interference characteristic and robustness.
81 The paper mainly introduces a dynamic simulation of step input PID control, which is conducted on a DC servomotor operated on MATLAB.
82 A simple PID tuning method based on dominant pole placement and phase margin specification is proposed.
83 A strategy for integral separation PID sliding mode control is proposed.
84 Aimed at the problems of parameter manual tuning method of PID controller in DCS of power plant, puts forward the auto-tuning method based on the step identification.
85 In the industrial processes, most of the plant has the characteristic of the time delay, which refuses the plant to get the ideal control response by using the normal algorithm, such as PID.
86 The results from the new intelligent PID control system show that a satisfactory control effect is achieved by the secondary regulation hydrostatic automotive transmission.
87 Thedesign is a closed loop control system that consists of a linear DC motor drived by LMD18245, a linear capacitive grid displacement transducer and a digital PID controller.
88 Hence, the research on automatic tuning and adaptation technologies for PID control is on the agenda.
89 This paper calculates PID gas load of SR from a 6 T superconducting Wiggler at HLS.
90 Compared with the conventional PID masterslave control method, the move mean difference is reduced by 18.2% and the move standard deviation is reduced by 61.5%, and the exposure effect can be ensured.
12345678