ignition造句91. The characteristic of ignition system is related to igniting rate and influence fire accuracy.
92. The phenomenon of boron particle ignition in hot air was defined.
93. In the paper, the dependability of explode energy of blasting fuse through space attenuation ignite the high energy ignition compositions was learned.
94. In spite of this, when a certain wood reaches flame-flash or ignition, the temperature of the surface does not vary with the change of grain distribution.
95. The ignition delay fault of solid rocket motor happening in a low temperature based on FTA is analyzed in the paper.
96. The ignition characteristics, law and production of CO and CO2 are insignificantly different among three woods. Pine produces most smoke and basswood least.
97. With the rise of heating rate, the maximum release rate of volatile and combustion rate of char, the burnout temperature and the combustible parameter increased, but the ignition temperature...
97.try its best to gather and create good sentences.
98. The software of the engine management system includes 5 main models. The models are intake model, ignition control model, injection model, idle speed model, diagnosis and emergence operation model.
99. Base on such system, the fuel injection MAP and advanced ignition angle are achieved by matching test.
100. By means of analysis on ignition fail reason of auxiliary combustion chamber for catalytic cracking unit, the unreasonable place existed in igniter was found, and improvement plan was given.
101. A uniform method to control the electrify timing of the ignition coil is proposed, and it eliminates the disadvantages brought by ignition division.
102. The process design for ignition furnace in sintering production to use B. F . gas as the only fuel with preheating technique and its application are introduced.
103. Disconnect the secondary spark plug cable from the ignition coil.
104. Cautions during transportation:Avoid exposing to air, sunlight, heating, shock, moisture, or any sources of ignition Or other readily oxidizable materials.
105. The problem of annual arc welding power source whose output is surge and power factor is lower, is solved by means of main circuit, arc ignition circuit and arc static circuit working together.
106. The ignition of both deal and fir blocks were tested a bench scale flashover test apparatus.
107. The temperature and fuel concentration on the surface decline by adding water in fuel and consequently prolong the ignition delay.
108. Smoldering and ignition caused by radiation are special phenomena in disaster combustion and don't exist in modern combustion equipment.
109. The ballistic simulator was used to make experiments of ignition simultaneity of the normal centre core ignitor and the LVD centre core ignitor to propellants.
110. The potassium picrate in the formula can help to reduce the ignition delayed time and pressure rise time.
111. Main products:Ignition Switch, combination Switch, Power window switch and other auto electrical parts.
112. The cranking ignition timing table is used up to this speed on starts.
113. To electrically start a vehicle lacking using an ignition key.
114. If you park in a commercial lot or garage , leave only ignition key with the attendant.
115. Limb orientation perforating gun and sectionalized two orientation delayed ignition technology were used in the test.
116. The simulation of this thesis is designed about the Rayleigh fading and the ignition noise of automobile.
117. Both three kind of single and two parallel connecting water-activated battery may rapidly and reliably fire common electric ignition head.
118. Duke-Honorable Series: Advanced ignition, Constant power output, Low-frequency component, 8-years over-long quality guarantee period.
119. Adjust ignition timing by gradually turning the distributor housing until the timing makes are aligned.
120. Then basic calibration such as ECU I/O calibration, idle speed calibration, cold start calibration, ignition advance calibration, air fuel ratio calibration, boost pressure calibration are conducted.